ASSE Standard #1060
AquaSHIELD ® is ASSE 1060 (2017) Class I, II and III certified.
The standard for performance requirements for outdoor enclosures for fluid conveying components, focuses on devices that provide a range of protection for fluid conveying components which are mounted outside & above ground so that they may avoid damage from freezing, vandalism and tampering. Fluid conveying components include backflow prevention assemblies and devices, water meters, control valves, pressure reducing valves, air release valves, pumps, and other components installed outdoors and above ground requiring protection from freezing and/or require system security protection.
General Information: No product may be said to be ASSE approved unless the manufacturer has applied to the ASSE, has had their product tested by an official ASSE recognized independent laboratory, according to the applicable ASSE Standard. When the product has passed the test, they can display the ASSE seal on the product.
This standard was promulgated in accordance procedures developed by the American National Standards Institute (ANSI).
The standards are copy righted. To obtain a printed text of the ASSE Standard # 1060 (Issued: 1996 or revised 2006, 2017) please contact:
American Society of Sanitary Engineering
Phone: (440)835-3040
Website: www.asse-plumbing.org
Email: [email protected]
AquaSHIELD ® is ASSE 1060 (2017) Class I, II and III certified.
The standard for performance requirements for outdoor enclosures for fluid conveying components, focuses on devices that provide a range of protection for fluid conveying components which are mounted outside & above ground so that they may avoid damage from freezing, vandalism and tampering. Fluid conveying components include backflow prevention assemblies and devices, water meters, control valves, pressure reducing valves, air release valves, pumps, and other components installed outdoors and above ground requiring protection from freezing and/or require system security protection.
General Information: No product may be said to be ASSE approved unless the manufacturer has applied to the ASSE, has had their product tested by an official ASSE recognized independent laboratory, according to the applicable ASSE Standard. When the product has passed the test, they can display the ASSE seal on the product.
This standard was promulgated in accordance procedures developed by the American National Standards Institute (ANSI).
The standards are copy righted. To obtain a printed text of the ASSE Standard # 1060 (Issued: 1996 or revised 2006, 2017) please contact:
American Society of Sanitary Engineering
Phone: (440)835-3040
Website: www.asse-plumbing.org
Email: [email protected]